Taski swingo 1650 Translation Of The Original Instructions Of Use page 6

Preparing to drive
• Switch on the keyswitch.
The indicators light up briefly.
Start
The battery indicator displays that the machine is
ready for operation
(on malfunction see page 27).
• Hold the handle and adjust the height of the
drive switch so that it can be operated
comfortably.
The drive switches can be moved up and down
by lightly pressing on them.
By lightly pressing the speed control in the
direction of drive, the machine is set in motion.
Letting the speed control go stops the machine.
Attaching tools
• Switch the machine off using the keyswitch and remove the key.
Check:
• that the brush has not fallen below the red mark or a brush length of 1 cm.
• the pad for wear before using.
Working with worn out, damaged and or wrong tools, could result
in possible damage to floors or their protective layers.
• Position the tool below the brush unit.
• Switch on the keyswitch.
The indicators light up briefly.
Start
Foot pedal
• Unlatch the foot pedal and slowly lower the tool.
While being lowered, the coupling begins to
slowly rotate. This centres and locks the tool
into place.
Attach squeegee
• Switch the machine off.
• Lay the squeegee under the squeegee holder.
• Position the squeegee so that the squeegee
holder is under the towing strap.
• Press the foot pedal down until the squeegee
locks into place.
• Plug the suction hoses into the squeegee
support.
24
Filling water
Caution:
Maximum permissible water temperature 60 °C/140 °F.
• Switch the machine off using the keyswitch and remove the key.
• Reach into the opening between the tank lid and
the tank.
Palm facing upwards.
• Open the lid until the self support locates on the tank wall.
• Remove the dosing aid.
• Fill water into the solution tank.
Maximum permissible filling level (page 22).
max.60 C
max.140 F
Dosage:
Caution:
Wear protective gloves, goggles and the corresponding
(protective) work clothing when handling chemical products!
Only use chemical products recommended by the manufacturer.
Caution:
The use of other chemical products (e.g. with acidic or chlorine
constituents) can damage or destroy the machine.
The dosing aid is designed for a 0.5% and 1% cleaning solution.
Dosing examples:
• Dosing aid application
• Add the product measured with the dosing cup to the water in the solution
tank.
• Lift the tank lid slightly.
• Gently press the tank lid support inwards.
• Close the tank lid.
• By exerting slight pressure onto the front of the lid, you can click it into the
latch.