Hitron CGNVM User Manual page 58

Table 14: The Basic: LAN Setup Screen (continued)
LAN DHCP Status
Lease Time
DHCP Start IP
DHCP End IP
Save Changes
Cancel
Help
Connected Computers
Host Name
IP Address
MAC Address
Type
Interface
58 58 Version 1.0, 02/2015. Copyright
Version 1.0, 02/2015. Copyright
Hitron CGNVM User's Guide
Use this field to configure whether or not the CGNVM's
DHCP server is active.
To turn the DHCP server on, click Enabled.
To turn the DHCP server off, click Disabled.
Use this to select the time that elapses before your
device's IP address lease expires, and a new IP
address is assigned to it by the DHCP server.
Use this field to specify the IP address at which the
CGNVM begins assigning IP addresses to devices on
the LAN (when DHCP is enabled).
Use this field to specify the IP address at which the
CGNVM stops assigning IP addresses to devices on the
LAN (when DHCP is enabled).
NOTE: Devices requesting IP addresses once the
DHCP pool is exhausted are not assigned an IP
address.
Click this to save your changes to the fields in this
screen.
Click this to return the fields in this screen to their last-
saved values without saving your changes.
Click this to see information about the fields in this
screen.
This displays the name of each network device
connected on the LAN.
This displays the IP address of each network device
connected on the LAN.
This displays the Media Access Control (MAC) address
of each network device connected on the LAN.
This displays whether the device's IP address was
assigned by DHCP (DHCP-IP), or self-assigned.
This displays whether the device is connected on the
LAN (Ethernet) or the WLAN (Wireless(x), where x
denotes the wireless mode; b, g or n).
2012 Hitron Technologies
2014 Hitron Technologies
BASIC