Native Instruments MASCHINE STUDIO Manual page 812

14.2.4 Arming, Starting, and Stopping the Recording on Your Controller
Starting and stopping the recording.
Press Button 5 (START) to arm the recording.
►
After the recording has been armed, its behavior will depend on the recording mode you have
selected (via the MODE
Mode above):
▪ When recording in Sync mode:
◦ The recording will start at the next bar. Until then Button 5 flashes, the label under it
reads WAITING, and a
◦ Once the recording has started, the audio is recorded for the duration set by the
LENGTH control (see section
above). You can also press Button 5 (STOP) beforehand to stop the recording at the
next bar, or Button 6 (CANCEL) to cancel the recording (in that case the recorded au-
dio will not be saved).
▪ When recording in Detect mode:
◦ The recording will start as soon as the input signal exceeds the
Until then Button 5 flashes, the label under it reads WAITING, and a
INPUT... message appears underneath. During this waiting phase you can also start
the recording manually by pressing Button 5 (WAITING) or cancel the recording by
pressing Button 6 (CANCEL).
selector, see section ↑14.2.2, Selecting the Source and the Recording
WAITING FOR NEXT BAR...
↑14.2.2, Selecting the Source and the Recording Mode
Sampling and Sample Mapping
message appears underneath.
THRESHOLD
WAITING FOR
MASCHINE STUDIO - Manual - 812
Recording a Sample
value.