70
220V3
LCD
5
Mechanical characteristics
5.1
Cosmetic -
Philips ID
5.2
Mechanical data files -
ProE files required
5.3
Location of Philips logo -
Per Philips make-up sheet
5.4
Gap between panel and front bezel
15"~19": <0.8mm, 19"W:<1.0mm, 20"W~23"W: <1.2mm, 24"W: <1.4mm, 27"W:<1.5mm
5.5
Slant -
17"~19"W,20" : <3mm ,
Pivot angle : -0.5 ~-4.5 , 90.5 ~94.5
5.6
Location of Control icons -
Per Philips Graphic sheet
5.7
Color for resin/paint -
Per Philips make-up sheet
5.8
Fire enclosure request
Shielding Cover should fulfill international standard
5.9
Resins
RoHS required
WEEE required.
Resin type/selection refer to Project Book Section 7.2 Plastic material.
5.10 If paint is used
RoHS required
WEEE require
If new painting type need to implement, refer to UN-D 1235.
5.11 Plastic mold tooling
Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush,
weld lines, gate marks, ejector marks, etc.). Refer to "TYV61-90007".
Painting to cover up cosmetic defects due to molding is strongly discouraged.
20"W :<4mm
for SB,CEB
for SEB