Interface Signals - Philips 220V3SB/00 Service Manual

56
220V3 LCD

3.1 Interface signals

1). D-Sub Analog
Input signal
Video
Sync.
Composite sync TTL level, input impedance 2.2k ohm terminate (Positive/Negative)
Sync on green video 0.3 Vp-p Negative (Video 0.7 Vp-p Positive)
2). DVI-D Digital
3). HDMI ( option , refer to Quick specification table)
TMDS channel:
Video Timing Support :
Format
480i
480p
576i
576p
720p
: Video, Hsync., Vsync
: 0.7 Vp-p, input impedance, 75 ohm @DC
: Separate sync
Hsync
Vsync
Input signal: Single TMDS link (Three channels: RX0-/+, RX1-/+, RX2-/+)
Follow HDMI 1.4 specification
DDC channel:
Content protection:
HDMI video input should support timing defined in CEA 861-D
specification with extended EDID blocks
Resolution
720 x 480
720 x 480
720 x 576
720 x 576
1280 x 720
TTL level , input impedance 2.2k ohm terminate
Positive/Negative
Positive/Negative
Carries audio, video and auxiliary data.
Signaling method: According to DVI 1.0 specification.
Single-link (Type A HDMI).
Video pixel rate: 25 MHz to 165 MHz (Type A)
Pixel encodings: RGB 4:4:4, YCbCr 4:2:2, YCbCr 4:4:4.
Audio sample rates: 32 kHz, 44.1 kHz, 48 kHz
Audio channels: 2.
Allows source to interrogate capabilities of sink.
I²C signaling with 100 kHz clock.
E-EDID data structure according to EIA/CEA-861D and
VESA Enhanced EDID.
According to High-Definition Content Protection (HDCP)
Specification 1.10.
Type Vertical frequency
SD 60Hz
SD 60Hz
SD 50Hz
SD 50Hz
HD 50Hz , 60Hz