8 0
220V3
LCD
4. Power no output troubleshooting
Detach power board from the monitor and
if the +17V of the power board output
Yes
If the +17V of power board output normally
Check IC602 whether the C pin and
output normally
Check D711 whether the output keep +17V.
Change interface board
5. Inverter & LED driver no work troubleshooting
Check PIN 6 of CN701 whether the
voltage is +3.3V
Check PIN 7&8 of CN701 whether the
voltage is +5V
Replace the power board
Repair Flow Chart
No
normally
No
Yes
No
Yes
Yes
Yes
The power cord is good.
Yes
Yes
Replace the power board
Yes
No
Check the IC602 related signal
Check the D711, input signal and
open-short
No
Check the interface and power
board
No
Check the power board
No
Replace the power cord
Check connector whether .it is tilted