Using The Tr515 - Promag TR515 User Manual

2. Using the TR515

Clocking in and out
To register an event (IN or OUT), push the appropriate button and read your
ID-card. For the TR515R (RFID version), the card is read by bringing it close to
the reader (< 8 cm). For the TR515M, TR515B, and TR515F (Magnetic, Visible
Barcode and IR Barcode respectively), the card is read by swiping it in either
direction along the reader slot. For the machine orientation shown on figure of
page 3, magnetic (barcode) stripe of the ID-card must face downwards.
Note: the TR515 can be programmed to fix event selection to IN or OUT
only- in this case event selection won't work!
The last four digits of the ID-cards ID-code are displayed on the LED when
the ID-card is read. Four dashes are displayed in case of read error (only
applicable to the TR515M):
Memory full status
When the database memory is full, new records cannot be added. Reading
an ID-card will produce a long beep and a "FULL" message:
Error conditions
The TR515 can detect and notify you of a number of different error conditions.
Please refer to Appendix A for complete list of all possible errors.
Normal operation of the TR515 is suspended upon encountering an error
condition other than "card read error". New records cannot be added to the
database in this situation. Communications with the TR515 from the PC side is
still possible, however. This gives you an opportunity to access the TR515
online and attempt to correct the problem.
TR515 User's Manual
7