Table of Contents
Advertisement
Steps
1.
Align the tabs on the cooling shroud with the securing slots on the chassis.
2.
Lower the cooling shroud into the chassis until it is firmly seated.
When firmly seated, the memory socket numbers marked on the cooling shroud align with the
respective memory sockets.
Next steps
1.
Follow the procedure listed in the After working inside your system section.
Related Links
Before working inside your system
Safety instructions
System memory
Your system supports DDR3 ECC unbuffered DIMMs (UDIMMs).
NOTE: MT/s indicates memory module speed in Mega Transfers per second.
Memory bus operating frequency is 2133 MT/s depending on the following factors:
•
System profile selected (for example, Performance Optimized, Custom, or Dense Configuration
Optimized)
•
Maximum supported memory module frequency of the processors
The system contains four memory sockets — two sets of 2–sockets each. Each 2–socket set is organized
into one channel. In each 2-socket set, the first socket release lever is marked white and the second
socket release lever is marked black.
Figure 12. Memory socket locations on the system board
58
Advertisement
Table of Contents
Troubleshooting
