Rear Panel Controls - Laney Cub 212R User Manual

12
12
EXTENSION CABINET: Use to connect an 8-16 ohm extension cabinet. Please note mismatched impedance will
reduce the amplifiers performance and in some cases may cause damage to your amplifier. Try your CUB12R into a Laney
extension cabinet - you will be amazed.
13
EFFECTS LOOP: SEND/LINE OUT: Connect the input of your external effect to this socket. This is an insert type
control, therefore all of the signal leaves the amplifier via the `Send' socket to be processed. This socket can also be used
as a Line Level Out. (-10dBV Nominal)
EFFECTS LOOP: RETURN: Connect the output from your external effects to this socket. The effects loop allows you
to connect external effects such as tremolo, chorus and delay to your amplifier. (-10dBV Nominal)
14
FOOTSWITCH SOCKET: Provided for the connection of a Laney FS1 footswitch (optional) .This allows you to
remotely switch the built in Digital Reverb On/Off.
15
POWER INLET SOCKET: Connect to your power source. Make sure the specified voltage is correct for your
country!
16
POWER FUSE: This drawer contains the main safety fuse for the unit. USE ONLY THE CORRECT SIZE AND RATING
OF FUSE AS SPECIFIED ON THE PANEL. If a fuse blows or fails and a replacement of the same size and rating is installed
and it in-turn blows, the amplifier has suffered a malfunction internally and needs immediate service from a qualified
technician. DO NOT TRY USING A FUSE OF HIGHER RATING. This may cause serious, irreparable damage to the
amplifier and presents a serious fire hazard. The mains fuse ratings are detailed in the specification section at the rear of
this manual.
17
SERIAL NO: Displays the model details and serial number of the unit
13
(Always switch off and disconnect the power cord when not in use).
14

Rear Panel Controls

15
LZB1 2 3 4
16
17
7