Network Settings; Advanced Settings - D-Link DCH-M225 User Manual

Section 3 - Configuration
This page allows you to configure the Network Settings for the DCH-M225. To access this page from the Home page, click on the
Settings drop-down menu at the top of the page, and select Network.
Management You can change the device name in the management link
Link:
by editing the text in the text box. If you change this device
name, you will need to enter http://xxxx.local./ (where
"xxxx" corresponds to the name of the device) in the address
bar of your web browser in order to access the configuration
utility.
The Advanced Settings section of the Network Settings page allows you to configure both IPv4 and IPv6 settings that will be
used by the DCH-M225's extended network.
IPv4 Device Management Interface
My LAN Select whether you want the IP to have a Dynamic IP (DHCP)
or Static IP address. Select Dynamic IP to obtain the IP
Connection is:
address information automatically from your ISP (Internet
Service Provider.) If you choose Dynamic IP, the fields below
will be greyed-out.
Enter the Static IP Address you want to assign to the
IP Address:
extended network AP. This address should be outside of the
uplink router's DHCP address pool.
Enter the Subnet Mask.
Subnet Mask:
Gateway Enter the Gateway Address. (Usually this is the IP address
of the uplink router.)
Address:
D-Link DCH-M225 User Manual

Network Settings

Advanced Settings

27