Table of Contents
Advertisement
Section 3 - Configuration
This page lets you configure the network settings for the DAP-1620. To access this page, click the Settings drop-down menu at the
top of the page, then select Network. Click Save at any time to save the changes you have made on this page.
Management Link
You can change the URL name of the device by editing the text in
the text box. If you change the name of the device, you will need
to enter "http://xxxx.local. " (where "xxxx" corresponds to the name
of the device) in the address bar of your web browser in order to
access the configuration utility.
Advanced Settings
The Advanced Settings section of the Network Settings page allows you to
configure both IPv4 and IPv6 settings that will be used by the DAP-1620's
extended network.
Here you can select whether you want the IP to have a Dynamic
My LAN
IP or Static IP address. If you select Dynamic IP, the options below
Connection is
will not be available.
IP Address
Enter the Static IP address that you want to assign to the extended
network AP. This address should be outside of the uplink router's
DHCP address pool.
Subnet Mask
Enter the subnet mask.
Gateway Address
Enter the gateway address. This is usually the IP address of the
uplink router.
Primary DNS
Enter the address of the primary DNS server.
Server
Secondary DNS
Enter the address of the secondary DNS server. This is optional but
Server
will provide backup if the primary server fails.
D-Link DAP-1620 User Manual
Network Settings
IPv4
38
Advertisement
Table of Contents
