Network Settings; Advanced Settings - D-Link DAP-1320/B1A User Manual

Section 3 - Web-based Coniguration
This page lets you conigure the network settings for the DAP-1320. To access this page, click on the Settings drop-down menu
at the top of the page, and select Network. Click Save at any time to save the changes you have made on this page.
Device Name: You can change the name of the device by editing the text in
the text box. If you change the name of the device, you will
need to enter "http://xxxx.local. " (where "xxxx" corresponds
to the name of the device) in the address bar of your web
browser in order to access the coniguration utility.
The Advanced Settings section of the Network Settings page allows you to conigure both IPv4 and IPv6 settings which will
be used by the DAP-1320's extended network.
IPv4 Device Management interface - You can select either a Dynamic or Static IPv4 coniguration:
My LAN
Here you can select whether you want the IP to have a
Connection is:
Dynamic IP or Static IP address. If you select Dynamic IP,
the options below will not be available.
IP Address:
Enter the Static IP address that you want to assign to the
extended network AP. This address should be outside of the
uplink router's DHCP address pool.
Subnet Mask:
Enter the subnet mask.
Gateway
Enter the gateway address. This is usually the IP address of
Address:
the uplink router.
Primary DNS
Enter the address of the primary DNS server.
Server:
Secondary
Enter the address of the secondary DNS server. This is
DNS Server:
optional but will provide backup if the primary server fails.
D-Link DAP-1320 User Manual

Network Settings

Advanced Settings

24