Table of Contents
Advertisement
Section 3 - Configuration
This page lets you configure the network settings for the E15. To access this page, click Settings > Network.
Click Save to apply the settings and a reboot may be required.
Management Link
You can change the URL of the device by editing the text in
the box. If you You can replace E15-xxxx with a name of your
choice for "http://E15-xxxx.local./" (where "xxxx" represents the
last 4 digits of the MAC address). However, you will need to
enter the modified URL in the address bar of your web browser
to access the configuration utility.
The Advanced Settings section of the Network Settings page allows you to
configure both IPv4 and IPv6 settings for communicating with the E15.
My Internet
Here you can select the method of assigning an IP address to
Connection is
the E15: Dynamic IP or Static IP addressing mechanism. If
you select Dynamic IP, the options below will not be available.
IP Address
Assign an IPv4 address. This address should be outside of the
uplink router's DHCP address pool.
Subnet Mask
Enter the subnet mask. It is used to determine the subnet of
an IP address.
Gateway Address
Enter the gateway address. This is usually the IP address of
the uplink router.
Primary DNS
Enter the address of the primary DNS server. It is the address
of the server used to resolve hostnames to IP addresses.
Secondary DNS
Enter the address of the secondary DNS server. This is optional
but will provide backup if the primary server fails.
D-Link E15 User Manual
Network Settings
Advanced Settings
IPv4
32
Advertisement
Table of Contents
