Omron V740-BA50C22A-US Operation Manual page 37

1. ID Lock
The UPDATE command is also used to lock
data of a tag. This can be used to write '1' to
'locked' flag . The structure of an UPDATE
command is the same as ID Write.
•
Example : To lock tag id of a 64-bit EPC tag:
UPDATE tag_id SET locked=1,
id=0x1234567890ABCDEF WHERE
protocol='EPC1' AND antenna_id=1;
The reader returns the tag_id if the lock
operation was successful. For example the
response is as follows:
|0xCE851234567890ABCDEF<LF><LF>
In this case, "CE85" is the check code.
"1234567890ABCDEF" is tag data(tag id).
If the operation is failed, "Error 0102: Error
performing query<LF><LF>" returned.
•
Example : To lock tag id of a 96-bit EPC tag:
Table4 : Table Schema - Tag Lock
Keyword Entry
UPDATE tag_id
SET locked
id
WHERE antenna_id
protocol_id
V740 RFID READER/WRITER, ANTENNA
OPERATION MANUAL
Table Arguments
- -
tag_id Int
tag_id Hex String
tag_id Int
tag_id String
37 of 56
UPDATE tag_id SET locked=1,
id=0x1234567890ABCDEF12345678 WHERE
protocol='EPC1' AND antenna_id=1;
The reader returns the tag_id the same way as 64-
bit tag.
Note: The format of the tag data in the command
must much the selected protocol or an error will
result. (See section 1.6)
For example :
- A 64 bit EPC1 tag requires 16 hexadecimal digits
- A 96 bit EPC1 tag requires 24 hexadecimal digits
Note: You must send this command to only one tag
at one time in the stable communication area.
Note: Response data always contains a separator in
front of the tag ID.
Note: If the response of the command is different
from the ID of the tag in the communication area,
you need to retry it.
Range Example
Value
- -
1 1
- 0xFEDCB
A0987654
321
[1...4] 1
'EPC1' 'EPC1'
Comments
Tag id database
table (Fixed)
Can be specified
with only "1"(Fixed).
Specifies the tag id
to be updated
Specifies the
antenna used to
update a tag
Specifies the
protocol used to
update a tag.
Must be uppercase.
2005-09, REV0.1
©OMRON CORPORATION 2005