Table of Contents
Advertisement
Network Settings: Ethernet Interfaces
Item
Use DHCP
Select whether the reader gets an IP address on the
network automatically by DHCP or manual setting. You
must not check the item if you use a manually set IP
address.
Vendor
Class
Specify an extra DHCP parameter for integration and
Identifier
customization. It is not supported on the firmware version
2.2.22.
Use
DHCP
Set this to yes to allow the DHCP server to assign the
Server Supplied
reader a hostname.
Hostname
LAN IP Address
Specify a unique IP address on the network when manually
set. It is given automatically by the DHCP server, if using
DHCP.
LAN Netmask
Specify the mask value to determine the network address
of the subnet from the IP address. It is not used if using
DHCP.
LAN Gateway
Specify a unique IP address for the gateway machine only
when communicating with the device on another LAN. You
don't have to set the item when communicating with the
device on the same LAN. Also It is not used if using DHCP.
Fallback
IP
IP address to be used If any DHCP server can't be found
Address
when in DHCP mode.
Fallback
Subnet mask to be used if any DHCP server can't be found
Netmask
when in DHCP mode.
Fallback
Default gateway to be used If DHCP server can't be found
Gateway
when in DHCP mode.
V740 RFID READER/WRITER, ANTENNA
OPERATION MANUAL
Describe
21 of 56
Setting
Default
Requirement
Optional
Yes
Optional
mercury4
-
No
Mandatory
(in
10.0.0.101
the case of not
using DHCP)
Mandatory
(in
255.255.255.0
the case of not
using DHCP)
Optional (in the
10.0.0.1
case of not using
DHCP)
Optional (in the
(none)
case
of
using
DHCP)
Optional (in the
(none)
case
of
using
DHCP)
Optional (in the
(none)
case
of
using
DHCP)
©OMRON CORPORATION 2005
2005-09, REV0.1
Advertisement
Table of Contents
