Table of Contents
Advertisement
RFID Protocol Settings
The RFID protocol settings take effect immediately on the reader upon saving them. A restart is not required.
The Default RQL Query runs continuously at startup and thus a change to this setting requires a restart of the
reader.
Item
UHF Power
UHF Output power in dBm. This setting must be adjusted
(dBm)
carefully to comply with FCC regulations.
Radio buttons that enable combined 96- and 64-bit tag
EPC1 Tag ID
support or single tag id lengths. If the reader will only be
length
reading 96- or 64-bit tags, select that radio button to
optimize read rates.
Maximum number of EPC0 tags to be singulated on each
EPC0 Search
query.
Depth
(This function is not available as this type of the V740
reader does not support EPC0 protocol.)
Initial query to be run continuously when reader starts up.
The most recent command entered is performed
Default RQL
automatically and continuously every second after
Query
rebooting the reader.
Once a user program has connected to port 8080, the
results of the command will be available.
V740 RFID READER/WRITER, ANTENNA
OPERATION MANUAL
Describe
19 of 56
Setting
Default
Requirement
Mandatory
30.0
Optional
64-bit/96-bit
Optional
80
Optional
(none)
©OMRON CORPORATION 2005
2005-09, REV0.1
Advertisement
Table of Contents
