Omron V740-BA50C22A-US Operation Manual page 24

Firmware Upgrade Page
Use the Firmware upgrade page to update firmware.
Only the update firmware file provided by OMRON
can be used.
1. Click the Firmware link on the navigation menu.
The Firmware upgrade page appears.
2. Place the cursor in the Filename field and type
the complete URL network pathname of the
firmware or click the Browse button to locate the
new firmware file.
3. Be sure to click both check boxes if you want the
reader to revert to safe-mode settings (Ref.
section 1.5.3.).
The lower check box becomes enabled after
clicking the check box above.
4. Click the Update button to download the new
firmware to the reader. The status frame at the
bottom of the page displays the progress of the
update.
5. To activate the new firmware, restart the reader.
Until the reader is restarted, the old firmware will
still be active.
In the unlikely event that a firmware update fails,
perhaps due to a power failure, the device will restart
in Safe Mode.
Note: You should not check the check box of 'Erase
contents before installing'. Or the V740 Reader loses
the function of I/O control(See section 3).
If the V740 Reader loses the I/O function, you should
query OMRON to tell the way of recovering the
function.
V740 RFID READER/WRITER, ANTENNA
OPERATION MANUAL
Restart Page
Use the Restart page to restart the reader.
1. Click the Restart link on the navigation menu. The
Restart Reader page appears.
Browse
2. To restart the reader, click the Restart System
button. The following dialog box appears.
3. Click OK. The following message appears and
remains on the screen until the reader restarts.
Then the Status page appears.
24 of 56
2005-09, REV0.1
©OMRON CORPORATION 2005