Test And Repair Of Rope Seal; Ash Removal - Boru Stoves Carraig Mor Installation & Operation Instructions

14. TEST & REPAIR OF DOOR GASKET (ROPE SEAL)
You will need to replace the rope seal a minimum of once a year using the following steps:
 Remove the original rope seal by grasping an end and pulling firmly
 Wearing safety goggles and gloves use a wire brush to clean the rope channel of any
remaining adhesive or bits of rope
 Starting at the bottom centre of the door apply rope adhesive generously into the rope
channel
 Do not over tension the rope when laying it into the channel
 Ensure both ends of the rope connect to form a snug & sealed joint
 Allow 24 hours to dry before lighting the stove
WE BELIEVE THAT YOU HAVE WISELY INVESTED IN HEATING YOUR HOME BY BUYING A
BORU STOVE. TO PROTECT THIS INVESTMENT AND EXTENDED WARRANTY COVER
PLEASE ADHERE TO THE INSTALLATION, OPERATION & MAINTANENCE GUIDELINES SET
OUT IN THIS MANUAL – IF YOU HAVE ANY QUERIES PLEASE CONTACT YOUR INSTALLER
OR LOCAL AGENT IMMEDIATELY.

15. ASH REMOVAL

 You should always wear protective gloves when removing ash
 If possible, this should be done before lighting the stove when the ash is cold
 To empty the ash, riddle the ash into the ash pan. When the ash pan is full remove it using
the multi tool provided
 To remove the ash, open the stove door and use the multi-tool provided to lift the ash pan
out of the stove – see page 26 for diagram
 Even if the ash appears to be cold, it should be placed in a non-combustible lidded
container as there may be hot ash in the centre of the pile. Close the lid of the container
 The closed container of ashes should be placed on a non-combustible floor or on the
ground, well away from all combustible materials, pending final disposal
 Always close the stove door when you have taken out the ash tray and leave closed while
disposing of the ash
 Only re-open the door to put ash pan back into the stove and close immediately afterwards
 Do not place any other waste in the container
 This stove is NOT designed to operate with the door open
25