Kenwood DDX4017DAB Instruction Manual page 63

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
❏ Installation procedure
1
To prevent a short circuit, remove the key
from the ignition and disconnect the
battery.
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Take Connector B on the wiring harness
and connect it to the speaker connector in
your vehicle.
5
Take Connector A on the wiring harness
and connect it to the external power
connector in your vehicle.
6
Connect the wiring harness connector to
the unit.
7
Install the unit in your car.
• Make sure that the unit is installed securely
in place. If the unit is unstable, it may
malfunction (eg, the sound may skip).
8
Reconnect the · battery.
9
Press the reset button. (Page 3)
10
Configure <Initial Setup>. (Page 4)
Installing the unit
❏ Installing the unit
·
• Bend the tabs of the mounting sleeve with a
screwdriver or similar utensil and attach it in place.
❏ Installing the trim plate
Attach the trim plate (2).
2
ENGLISH 63