Kenwood DDX4017DAB Instruction Manual page 48

SETTINGS SETTINGS
❏ Setting the speakers—car type,
speaker size and crossover frequency
Preparation:
Select the appropriate crossover network mode
beforehand. (Page 47)
1
Display the <Car Setting> screen.
On the Home screen:
2
Select a car type (1), select the location
of the speakers (2)* 1 , then display the
<Speaker Select> screen (3).
48
3
Select the speaker type (1), select the size
of the selected speaker (2), then display
the <X'over> screen (3).
• When a speaker is not connected, select
<None>.
• When setting the front speakers, also select
the speaker size for <Tweeter>.
4
Adjust the crossover frequency of the
selected speaker.
<TW Gain (L)>/ Adjusts the output volume of
<TW Gain (R)> the tweeter (left/right).*
<TW FREQ> Adjusts the crossover
frequency for the tweeter.*
<Gain> Adjusts the output volume of
the selected speaker.
<HPF FREQ> Adjusts the crossover
frequency for the front or rear
speakers (high pass filter).*
<LPF FREQ> Adjusts the crossover
frequency for the subwoofer
(low pass filter).*
<Slope> Adjusts the crossover slope.*
<Phase> Selects the phase for the
subwoofer.*
1
* Speaker location selection is available only when <X'over
Network> is set to [2 way]. (Page 47)
2
* Appears only when the front speakers are selected.
* 3 Adjustable only when <Tweeter> is set to <Small>,
<Middle>, or <Large> on the <Speaker Select>
screen.
4
* Appears only when the front/tweeter or rear/mid range speakers
are selected.
* 5 When <X'over Network> is set to [2 way] (Page 47):
Appears only when the subwoofer is selected.
* 6 Not adjustable when <HPF FREQ> or <LPF FREQ> is set to
<Through>.
2 * 3
2 * 3
4
5
6
5