If groove depth is less than specified:
Replace the guide bar.
N
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
MSE 220
Motor Cooling
Cooling air flows to the motor through
the slots in the front handle.
Use a dry brush or similar tool to
N
clean the cooling slots at regular
intervals – see "Maintenance
Chart".
Storing the Machine
For periods of 3 months or longer
Disconnect the plug from the wall
N
outlet.
Remove the saw chain and guide
N
bar, clean them and spray with
corrosion inhibiting oil.
Thoroughly clean the machine,
N
especially the cooling air inlets.
If you use a biological chain and bar
N
lubricant, e.g. STIHL BioPlus,
completely fill the chain oil tank.
Store the machine in a dry and
N
secure location – out of the reach of
children and other unauthorized
persons.
English
21