Pentair IntelliComm Installation And User Manual page 33

3.
To enable Feature 3:
already selected. Press the Enter button to save the setting.
4.
To set the flow rate for Feature 3:
the Select button to access the setting. To edit the flow rate (GPM) setting, see step 6.
5.
To set the start and stop time for Feature 3:
Stop Time" setting. Press the Select button to access the setting. To edit the start and stop time, see
step 6.
6. Press the Select button to change the current value.
7. To change the value, press the Left and Right arrows to select which digit to modify, then use the Up
and Down arrows to change the selected digit.
8. When you are done, press the Enter button to save the changes. To cancel any changes, press the
Escape button to exit edit mode without saving.
IntelliFlo
Features
Feature 3
Filter Vacuum
On
Warn.
Alarm
Feature Feature
1
Filter Cycle Examples
Flow
20 gpm
8:00 am
Original Filter Cycle w/No Timed Feature
Note: Refer to page 20 for further explaination.
Press the Select button then the Down arrow button to select Enabled if not
Press the Down arrow button to select "Set Flow" setting. Press
®
5:22
Back
Manual
Wash
Enter
Start
Reset
2 Stop
Filter
Cycle
10:00 PM
Press the Down arrow button to select "Start Time" or
®
IntelliFlo
Feature 3 4:50
Disabled
Activation
Back
Filter Vacuum Manual
Wash
+
+
On Enter
Enter
Warn.
Alarm
Feature Feature Start
Reset
1 2 Stop
Flow
50 gpm
20 gpm
Filter
Cycle
Time
8:00 am 6:00 pm
New Flow/Time Optimized Filter Cycle
®
IntelliFlo
Feature 3 5:18
Enabled
Activation
Back
Filter Vacuum Manual
Wash
Enter
On
Warn.
Alarm
Feature Feature Start
Reset
1 2 Stop
Feature 3
6:10 pm
9:45 pm
IntelliFlo Installation and User's Guide
27
Time