Loading Setpoints From A File - GE Multilin MM300 Quick Start Manual

WORKING WITH SETPOINTS AND SETPOINT FILES

Loading setpoints from a file

CAUTION:
38
1. In the files pane, right-click on Files and select the Add Existing Setting File item as
shown:
2. The Open dialog box will appear, prompting the user to select a previously saved
setpoint file. As for any other MS Windows® application, browse for the file to be
added then click Open. The new file and complete path will be added to the file list.
An error message will occur when attempting to download a setpoint file with a
revision number that does not match the relay firmware. If the firmware has been
upgraded since saving the setpoint file, see Upgrading Setpoint Files to a New Revision,
above, for instructions on changing the revision number of a setpoint file.
The following procedure illustrates how to load setpoints from a file. Before loading a
setpoints file, it must first be added to the EnerVista MM300/MM200 Setup environment as
described in the section, Adding Setpoints Files to the Environment.
1. Select the previously saved setpoints file from the File pane of the software main
window.
2. Select the Offline > Edit Settings File Properties menu item and verify that the
corresponding file is fully compatible with the hardware and firmware version of the
target relay. If the versions are not identical, see Upgrading Setpoint Files to a New
Revision, above, for details on changing the setpoints file version.
3. Right-click on the selected file and select the Write Settings File to Device item.
4. Select the target relay from the list of devices shown and click Send. If there is an
incompatibility, an "Incompatible Device" error message will occur:
MM300 MOTOR MANAGEMENT SYSTEM – QUICKSTART GUIDE
CHAPTER 2: INSTALLATION