Data And Event Logging Options; Data Logging Options; Digital Network Options; Menu Structure - Hach sc100 1720E Instrument Manual

Operation

4.7 Data and Event Logging Options

4.7.1 Data Logging Options

Sensor Data Log:
Step Select
1
2
3
4
5
6

4.8 Digital Network Options

4.9 Menu Structure

4.9.1 Sensor Diagnostics Menu

SELECT SENSOR
ERROR LIST
WARNING LIST
36
The sc100 provides two data logs (one for each sensor) and two event logs (one
for each sensor). The data logs store the measurement data at selected intervals.
The event log stores a variety of events that occur on the devices such as
configuration changes, alarms, and warning conditions. The data logs are stored
in a packed binary format and the event logs are stored in a CSV format. The logs
can be downloaded through either the digital network port or the IrDA port using
the file transfer program available from the manufacturer.
The default datalogging frequency is 15 minutes. If the datalogging frequency is
set to 15 minute intervals, the instrument can continue to store data for
approximately six months.
Highlight sensor of interest if more that one sensor is attached.
(select from 30 sec., 1 min., 5 min., 10 min., 15 min.)
Main Menu or Main Measurement Screen
The sc100 provides two digital communication methods with the controller
(the digital network port and the IrDA port). Either of the digital ports can be used
to access setup data, measurement data, or data/event logs. For the features
available for each individual digital network port, refer to the instruction sheet
supplied with the selected network card.
Displays a list of errors that are present. See
Displays a list of warnings that are present. See
Menu Level/Instructions
MAIN MENU
SENSOR SETUP
CONFIGURE
DATALOG INTERVAL
section 7.1 on page
section 7.2 on page
52.
52.
Confirm
—
—