Table of Contents
Advertisement
20
Operation Instructions
Phase 6 - Configuring Access Levels
Step Description
Access Levels are controlled by creating UserGroups and assigning the
UserGroup to a User as described in section 'Configuring Users'.
UserGroups are created by combining pairs of DoorGroups with
1.
Timezones. Each UserGroup can have up to 6 pairs of DoorGroups and
Timezones. Select DoorGroups and Timezones from the drop-down menus
to add to the current UserGroup.
2.
Timezones are the periods of time for each day of the week that access
will be granted. Select times and tick the days of the week this time is valid.
4 time periods can be created for each timezone. Select 'Holiday Access'
to grant access for holiday periods. Double click on the 'Holiday Access' to
add days to the holiday periods. Use the calendar to select these days.
3.
DoorGroups are created by grouping doors together. e.g. all the entry and
exit doors could be grouped together as 'Peremiter Doors'. Select a Door
from the 'All Available Doors' window and drag it to the 'Doors in Current
Group' to add it to the Door Group. Repeat for adding doors as desired.
Phase 7 - Downloading Configuration
Step Description
After all users, access levels and door control settings have been finalised,
a full download to the controller should be carried out.
1.
Go to the 'Settings' tab and click on 'Download Configuration'. A pop-up
window will appear, tracking the status of the download. All settings will be
downloaded to the Controller and Door Controls.
Network Diagrams for Single Controller
Connect DB9 cable
to serial port on PC
Maximum cable
length 10 meters
PC Direct Connection can be used, when
using ONLY one GSD Controller.
Set the Direct address to
ALL dip switches OFF
(see below )
Direct Connect - All Dip Switches OFF
See page 11 on "Configuring Controller Communication" to setup the application
for serial communications
Network Diagrams
DB9 Female
Serial Cable
A
1
B
6
2
0V
7
TX
3
8
RX
4
9
5
A
B
0V
9
Advertisement
Table of Contents
