Table of Contents
Advertisement
14
Operation Instructions
Phase 1 - Setting up the GSD Controller
Step Description
1.
Install the main TS SMART Controller and power up
2.
Begin by Defaulting/Restore Factory Settings on the controller via the
dip switch settings (see instructions on page 11)
3.
Important! Once powered up and the controller has completed the default
the process – reset the dip switches to the correct address positions.
(see instructions on page 11)
4.
Follow instructions on the CD provided to install the GSD PC application.
To download the latest drivers, enter the following link in your web browser.
http://www.globalsecurity.ie/userfiles/files/GSDWin Access en-US.zip
Note: Make sure the USB enrollment reader is not connected to the PC
before the GSD application is installed.
5.
Launch the application:
A. Launch the application by clicking the GSDWin icon on the desktop. The
"Site Database Management" will appear.
B. Click on "Create New Site", then click "Create New Wi-Enterprise Site"
and save the name of the new installation site. The application will then
launch.
C. Log in to the application as the Engineer (not the administrator) with the
password 6666.
D. Connect to the Controller. Refer to page 12 & 13 for setting up DHCP
or Static IP addresses
E. The Controller icon will change colour from gray (off-line) to
green (on-line) to show that the Controller is communicating with the
application.
F. Go to the 'Current Events' tab to view the current log messages from
the Controller
Phase 2 - Configuring the GSD Controller
Step Description
1.
Open the 'Doors' tab in the main menu to add the required number of new
doors to be part of this network. One door will already be added by default.
Click on the "+" button to add new doors. "-" to remove doors.
2.
Make sure all doors are "Enabled" and then click "Save".
3.
Open the Settings Tab and do a "Configuration Download" to the Controller
– this gives the Controller a clean set of instructions before beginning to
enroll doors onto the network.
4.
Create a New Wireless Network.
WARNING!
A New Network should only be created on first installation.
Creating a new network will overwrite any existing network information
and any enrolled Door Controls will be un-enrolled. All Door Controls will
have to be defaulted and re-enrolled on the new network that has just
been created!
A new network is now ready to be created.
Go to the 'Controllers' tab and Click on 'Wireless Network' and then click
on 'Create New Network'.
Click Yes on the pop-up to proceed.
Note: It will take about 20 - 60 seconds to complete. a pop-up will appear
when the network has been created.
Operation Instructions
15
Advertisement
Table of Contents
