The Rbrc ® Seal; Fcc, Acta And Ic Regulations - VTech CS6948-3 User Manual

®
The RBRC
®
The RBRC seal on the nickel-metal
hydride battery indicates that VTech
Communications, Inc. is voluntarily
participating in an industry program to
collect and recycle these batteries at the
end of their useful lives, when taken out
of service within the United States and
Canada.
®
The RBRC program provides a
convenient alternative to placing used
nickel-metal hydride batteries into the
trash or municipal waste, which may be
illegal in your area.
VTech's participation in RBRC
easy for you to drop off the spent battery
at local retailers participating in the
RBRC program or at authorized VTech
®
product service centers. Please call
1 (800) 8 BATTERY
Ni-MH battery recycling and disposal
bans/restrictions in your area. VTech's
involvement in this program is part of its
commitment to protecting our environment
and conserving natural resources.
®
RBRC and 1 (800) 8 BATTERY
are registered trademarks of
Rechargeable Battery Recycling
Corporation.
seal
®
makes it
®
for information on
®
FCC, ACTA and IC
regulations
FCC Part 15
NOTE: This equipment has been
tested and found to comply with the
requirements for a Class B digital
device under Part 15 of the Federal
Communications Commission (FCC)
rules. These requirements are intended
to provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
WARNING: Changes or modifications to
this equipment not expressly approved
by the party responsible for compliance
could void the user's authority to
operate the equipment.
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) this device
44