Installing Options - Oki C823n User Manual

Installing Options

This section explains how to install options on
your printer. The following options are available:
● Additional tray unit (Tray 2/3/4)
● Additional RAM (256 MB or 512 MB)
● 16 GB SD memory card kit
● Wireless LAN module
Note
● Be sure to turn off your printer and unplug the AC cord
and Ethernet or USB cable before installing options.
Installing options while your printer is turned on may
damage your printer and options.
Memo
● After installing options, set the option settings with a
printer driver. Refer to "When Adding Options"
Installing an Additional Tray Unit
Install an optional additional tray unit when
you want to increase the paper capacity of your
printer. You can install up to three additional tray
units. After installation, you need to configure
the printer driver settings.
N35110A
Reference
● For specifications of the additional tray unit, refer to
"Supported Paper" P.43.
CAUTION
It may cause injury!
● At least two people are needed to lift the printer
safely because it weighs about 37 Kg or 40 Kg.
1
Turn off your printer, and then unplug
the AC cord and the Ethernet or USB
cable.
Reference
● "Turning Off the Power" P.21
2
Stack an additional tray aligning a back
side of each tray.
P.41.
3
Place a printer on the additional trays
gently aligning the back sides of a
printer and the additional trays.
4
Plug the AC cord and Ethernet or USB
cable into your printer, and then turn on
the power switch.
- 23 -
Preparing Your Printer
1