Table of Contents
Advertisement
APPENDIX
FULL ASCII ( Code 39 ) NUMERIC TABLE
0
2
4
6
8
SETTING PROCEDURE
MIN / MAX LENGTH
STEP 1 - Scan: MIN LENGTH/ MAX LENGTH
STEP 2 - Scan: Two digits from Appendix.
STEP 3 - Scan: MIN LENGTH/ MAX LENGTH
Please note that when Min Length and / or Max Length are
enabled, the scanner will only read bar codes that fall into
those length parameters. Bar codes shorter or longer than
specified will not be read. The default lengths for these are
indicated in parentheses under the Min and Max bar codes
for each symbology.
NOTES:
1. The scanner will beep three times as a reminder that a
setting is not yet complete.
2. If you make a mistake, forget a step, etc., Scan RESET to
start again.
1
3
5
7
9
. P023$
Advertisement
Table of Contents
