Restore Factory Settings - HomeMatic HmIP-SMO-A Mounting Instruction And Operating Manual

Restore factory settings

10 Restore factory settings
The factory settings of the device can be restored.
If you do this, you will lose all your settings.
To restore the factory settings of the motion detector,
please proceed as follows:
• Open the battery compartment (D). The battery
compartment is located on the base unit. To
open it, you must remove the base unit from the
wall mounting bracket (A) (see figure 5).
• Turn the battery compartment cover (B) of the
motion detector anti-clockwise and lift if off.
• Remove the batteries.
• Insert the batteries ensuring that the polarity is
correct (see figure 6) while pressing and holding
down the system button (E) for 4 seconds at the
same time, until the LED quickly starts flashing
orange (see figure 5).
• Release the system button again.
• Press and hold down the system button again
for 4 seconds (see figure 5), until the device LED
lights up green.
• Release the system button to finish the procedure.
The device will perform a restart.
46