Safety and operating instructions
♦
Direct the hydraulic breaker in a position 90°
towards the object.
Start near the edge and work your way in towards
♦
the middle. Never start in the middle of large
objects.
Never run the hydraulic breaker longer then 15
♦
seconds on the same spot. Move the working tool
to a new position if the object does not break.
18
♦
Never bend with the working tool.
Use the correct feed pressure. When the feed
♦
pressure is correct the hydraulic breaker is working
at its best and the vibrations are at a minimum.
Also the wear on the bushing and inserted tool is
kept to a minimum.
♦
Listen to the sound from the hydraulic breaker.
The sound changes if there is any bending
between the working tool and bushing.
Never run the breaker with the boom cylinders at
♦
their end positions. It may cause damage to the
carrier.
9800 1050 01f | Original instructions
RX 2, 3, 4, 6, 8