Control System Fault Codes - Genie S-80 Service And Repair Manual

September 2015
Control System F ault C odes
Error Source Error Type
ID Name ID
21 Primary Up / 11
Down Joystick
12
15
16
17
22 Primary Up / 21
Down Directional
Valves
23 Primary Up / 12
Down Flow Valve
15
17
24 Angle sensor 11
12
15
16
17
31
26 Angle sensor 19
cross check
31 Secondary Up / 11
Down. Joystick
12
15
16
17
Part No. 1269074
Condition
Name
Value at 5V Function is inoperative.Alarm sounds
indicating a fault.
Value too high
Value too low
Value at 0V
Not calibrated
Fault Valve is operating outside of limits.
Alarm sounds indicating a fault.
Value too high Valve is operating outside of limits.
Value too low Alarm sounds indicating a fault.
Not calibrated Normal function except threshold for
one or both directions is zero.
Value at 5V Reduced speed function.
Value too high Alarm sounds indicating a fault.
Value too low
Value at 0V
Not calibrated
Invalid setup Initiate 1 -second beep of Alarm
Buzzer and required retract into safe
envelope
Out of range Reduced speed, required retract into
safe envelope
Value at 5V Function is inoperative. Alarm sounds
indicating a fault.
Value too high
Value too low
Value at 0V
Not calibrated
S-80 • S-85 • S-80X

Control System Fault Codes

Service and Repair Manual
Solution
Cycle power off, then on
after problem has been
corrected.
Calibrate joystick.
Cycle power off, then on
after problem has been
corrected.
Cycle power off, then on
after problem has been
corrected.
Calibrate valve threshold.
Cycle power off, then on
after problem has been
corrected.
Calibrate angle sensor.
Calibrate angle sensor.
Power up controller with
problem corrected
Cycle power off, then on
after problem has been
corrected.
Calibrate joystick.
89