Figure 1-6. Connecting The Utility And Usb Cable Assemblies - Ampro ReadyBoard 800 Quick Start Manual

Chapter 1
8) Connect USB 2 & 3 Cable
Assembly
9) Connect Utility Cable
Assembly
The Power-On switch turns the ReadyBoard 800 to an On condition,
NOTE
if your are using an ATX power supply. Normally, the operating
system (OS) will turn Off the ReadyBoard during the OS shut down
process. However, if you need to turn off the ReadyBoard, pressing
and holding the Power-On button for more than 4-6 seconds will turn
the ReadyBoard 800 to an Off state.
For information concerning power management and "sleep states"
under the ACPI standard, refer to the topic Power and Sleep States in
the ReadyBoard 800 Reference Manual.
ReadyBoard 800
• Connect the USB 2 & 3 cable assembly to J13 on the edge of the
ReadyBoard 800 as shown in Figure 1-6.
Refer also to Figures 1-1, 1-4.
• Connect the Utility cable assembly to J12 near the edge of the
ReadyBoard 800 as shown in Figure 1-6.
Refer also to Figures 1-1 and 1-4.
The Green Power-On switch uses Pins-1 & -2 of the Utility
♦
Connector.
The Red Reset switch uses Pins-2 and -3 of the Utility
♦
Connector.
Note: Reset Switch, LEDs, and capacitors
shown removed for clarity.

Figure 1-6. Connecting the Utility and USB Cable Assemblies

QuickStart Guide
Setting Up the ReadyBoard 800
Connect USB 2 & 3
Cable Assembly to J13
Connect Utility Cable
Assembly to J12
7