Figure 1-5. Connecting Audio In/Out And Atx Power Adapter Cable Assemblies - Ampro ReadyBoard 800 Quick Start Manual

Chapter 1
Skip any of the following steps that do not apply to your situation.
6) Connect the Audio In/Out
Cable Assembly
7) Connect the ATX Adapter
Cable Assembly
Connect the ATX Power Adapter
Cable Assembly to J1 and J2
Power-On (J1)
Power In
(J2)

Figure 1-5. Connecting Audio In/Out and ATX Power Adapter Cable Assemblies

6
• Connect the Audio In/Out cable assembly to J4 near the edge of
the ReadyBoard 800 as shown in Figure 1-5.
Refer also to Figures 1-1, 1-4.
• Connect the ATX Power Adapter cable assembly to J1 and J2 on
the edge of the ReadyBoard 800 as shown in Figure 1-5.
Refer also to Figures 1-1, 1-4.
The ATX power adapter was separated for non-ATX power
supplies and provides a separate power on/standby connector (J1)
from the power input voltage (J2).
• If you do not use an ATX power supply, you will have to provide
the standby voltage (+5V) to J1 for the soft off function.
Connect the Audio In/Out
Cable Assembly to J4
QuickStart Guide
Setting Up the ReadyBoard 800
Note: The PS/2 Keyboard/Mouse
connector is shown removed
for clarity.
Audio In/
Out (J4)
ReadyBoard 800