Chapter 1 Setting Up the ReadyBoard 800
Using this Guide
This guide provides the most efficient way to set up your ReadyBoard™ 800 single board computer
(SBC). The instructions provided in this guide include:
• Removing the ReadyBoard 800 from the shipping container and inventorying the accessories
• Connecting cables to the ReadyBoard 800
• Connecting the peripherals, boot devices, and power supply to the ReadyBoard 800
• Powering up the ReadyBoard 800
Information not provided in this QuickStart Guide includes:
• ReadyBoard 800 Specifications (Refer to ReadyBoard 800 Reference Manual)
• Environmental requirements (Refer to ReadyBoard 800 Reference Manual)
• ReadyBoard 800 connector/pin numbers and definitions (ReadyBoard 800 Reference Manual)
• Supplied software use and programming considerations (ReadyBoard 800 Reference Manual)
Requirements
The following peripherals and devices are needed to make full use of the ReadyBoard 800.
• Peripherals: (Customer Provided)
PS/2 Keyboard
♦
PS/2 Mouse
♦
CRT Monitor
♦
• Power Supply: (Customer Provided)
ATX or Lab power supply – This type of power supply is required to provide power to the
♦
ReadyBoard 800.
• Choice of Boot Device: (Customer Provided)
Floppy Disk drive
♦
IDE hard disk drive (See preinstalled OS Note in text)
♦
CompactFlash card (See preinstalled OS Note in text)
♦
CD-ROM
♦
• Optional Devices/Connections: (Customer Provided)
TFT Flat Panel
♦
Ethernet (or LAN Boot - Refer to ReadyBoard 800 Reference Manual)
♦
USB
♦
Audio components, such as stereo amplifiers, receivers, CD Players, and microphones
♦
What's in the Box
Refer to the QuickStart Kit Contents Sheet for a list of the cables, documents, and other items in the
shipping container.
ReadyBoard 800
QuickStart Guide
1