Getting Started; Connecting The Power - Dymo MobileLabeler User Manual

Getting Started

Follow the instructions in this section to set up your label maker.

Connecting the Power

The label maker is powered by a rechargeable, lithium-polymer (LiPo) battery . The
battery included with your label maker comes partially charged.
For best performance, fully charge the battery before using your label maker.
Inserting the Battery
Make sure all cables are disconnected
before inserting the LiPo battery.
To insert the battery
Press and then lift to open the
1
side cover of the label maker.
Insert the battery into the battery
2
compartment as shown in Figure 2.
Close the side cover of the label
3
maker.
Make sure to read the LiPo Safety
Precautions found on page 2.
Removing the Battery
Remove the battery when the label maker
will not be used for more than seven days.
Make sure all cables are disconnected
before removing the LiPo battery.
To remove the battery
Press and then lift to open the side
1
cover of the label maker.
Remove the battery from the battery
2
compartment as shown in Figure 3.
Make sure to read the LiPo Safety
Precautions found on page 2.
7 DYMO MobileLabeler
User Guide
Figure 2
Figure 3