Power Status Light; Battery Status Light; Bluetooth Connection - Dymo MobileLabeler User Manual

Power
The button turns the label maker power on and off. A short press of the
button turns the power on. A long press turns the power off.
A short press of the
After a period of inactivity, the printer will enter a power-saving standby mode. The
period of time before entering standby mode will vary based on your mobile
device.

Power Status Light

The power status light visually shows the power status of the label maker.
Status Light
Off
Glowing
Fast Blinking
Solid
When the label maker is turned on but not connected to a power source, the
power status light remains on but is dimmed.

Battery Status Light

The battery status light visually shows the charge status of the battery.
Status Light
Off
Moving
Solid

Bluetooth Connection

The label maker can connect to a maximum of two devices using Bluetooth
wireless technology. For example, two phones, a phone and a tablet, or a laptop
and a phone.
By default, the label maker is always discoverable when the power is turned on.
You can change the label maker's discoverability through MobileLabeler Options
in DYMO Label software.
 General - Always discoverable.
 Limited - Discoverable for two minutes.
 Off - Never discoverable.
When set to limited discoverability, the two minute discoverable time period can
be started by pressing the Bluetooth
5 DYMO MobileLabeler
User Guide
button will also cancel any ongoing print job.
Power Status
The power is turned off; the battery may still be charging if
plugged into a wall outlet.
The label maker is in standby mode.
The label maker is on and there is an error.
The power is turned on.
Label Maker Status
The battery is empty.
The battery is charging.
The battery is fully charged.
The battery is partially charged.
button on the back of the label maker.