Table of Contents
Advertisement
Converting the appliance to different gas types
7
Converting the appliance to different gas types
The setting is factory sealed at maximum. Adjustment to
the rated heat input and min. heat input is not neces-
sary.
Checking the gas supply pressure
B Check the gas supply pressure at the gas supply
pressure testing point.
Natural gas appliances must not be oper-
i
ated if the gas supply pressure is below
18 mbar or above 24 mbar.
LPG appliances must not be operated if
the supply pressure is below or above
37 mbar.
Natural gas
• Appliances for natural gas type G20 are factory set
to Wobbe-Index 15 kWh/m
pressure and sealed.
Conversion kits
For conversion
Model
from ...
R 28 HE
N.G to L.P.G
Table 15
• Instructions are sent with each conversion kit.
30
3
and 20 mbar supply
Order no.
7 710 149 049
7.1
Setting the gas/air ratio
The gas/air ratio may only be adjusted on the
basis of a CO
measurement at max. heat output
2
and min. heat output using an electronic tester.
B Switch off the appliance at the master switch (O).
B Remove the outer case (see page 15, refer to
fig. 15).
B Switch on the appliance at the master switch (I).
B Set room thermostat to maximum temperature.
B Open thermostatic radiator valves.
B Unscrew sealing plug from flue gas testing
point (234). Refer to fig. 43.
B Insert testing probe about 135 mm into the flue gas
testing point and seal testing point.
234.1
234
Fig. 43
B Press and hold
button until the display shows – –.
The
button will light up.
6 720 610 332-32.1O
Fig. 44
B Turn the temperature control
shows 2.0 .
After a short delay, the current operating mode set-
ting will be displayed (0. = Normal mode).
6 720 610 332-60.1O
Fig. 45
6 720 611 400-26.2O
until the display
6 720 611 443 GB (05.04)
Advertisement
Table of Contents
