Removing The Auto Cutter Sa; Removing The Lock Levers - TEC TRST-56 SERIES Maintenance Manual

3. DISASSEMBLY AND REASSEMBLY

3.3.5 Removing the Auto Cutter SA

1. Remove the four ST-3x6 screws to remove the auto cutter SA.
Main Chassis
Removing the Auto Cutter and Its Peripheral Parts
1. Remove the two M-3x4 screws and slide the auto cutter in the direction of the arrow to
remove.
2. Remove the EXT spring-03.
3. Pull out the safety cover shaft from the cutter plate and the safety cover.
4. Remove the safety cover from the cutter plate.
Auto Cutter

3.3.6 Removing the Lock Levers

1. Remove the EXT spring 01 from the lock lever-R-SA.
2. Pull out the ejector.
3. Remove the lock lever-R-SA from the right end of the lock lever-L-SA.
4. Remove the lock lever-L-SA by pulling it to the left.
Main Chassis
Lock Lever-L-SA
ST-3x6
Safety Cover
Safety Cover Shaft
Cutter Plate
EXT Spring-03
EXT Spring-01
Lock Lever-R-SA
3- 9
3.3 Disassembling the Mechanism Unit
Auto Cutter SA
Fig. 3-16
M-3x4
Fig. 3-17
Ejector
Fig. 3-18
EO18-13004