Table of Contents
Advertisement
13. RECHARGING BATTERIES IN BELT-PACK
TRANSMITTER
Recharging the Batteries
(NiMH Rechargeable Batteries ONLY):
Make sure there are NiMH recharge-
able batteries in the transmitter
before plugging in the charger.
Typical battery life is about 8 hours.
Fully charged Lightspeed transmitters
will last over 7 hours. A full charge will
be attained in 8-10 hours.
WARNING: Do not attempt to
charge alkaline batteries. They can
overheat and expand, creating a
significant hazard and damaging the
transmitter. (This is not covered by
warranty.)
1. Switch the transmitter power OFF.
2. Insert the small DC plug into the
jack on the side of the transmitter.
3. Plug the other end of the charger
into any standard 110 VAC outlet.
4. The RED LED on the charger will
light, indicating that charging is in
progress.
5. When the batteries are fully
charged, the LED on the charger
will glow GREEN.
27
Advertisement
Table of Contents
