Quick Start Guide
USING YOUR T3 MICROPHONES: JUST TAP-TO-TALK
The same T3 functionality works on Flexmike and Sharemike so
users can either wear them around the neck or as a hand-held
pass-around microphone.
Tap the power button on a T3 microphone to begin sharing
1
through the audio system
• The mode button will turn blue to indicate the microphone is
broadasting live.
To talk into different T3 microphone, just tap the power
2
button on that microphone
• The mode light will turn blue.
• The previously connected T3 will be disconnected, turning the
mode light back to white.
To mute or disconnect your T3 microphone from audio, just
3
tap the power button again.
• Status and power lights will turn white.
CHARGE T3 MICROPHONES NIGHTLY
The T3 microphones need to be charged on a nightly basis. On a full
charge the microphones will operate thoughout the school day.
• Place the T3 Microphones into the charging slot.
• The power light will turn red to indicate charging in process.
• When the T3 Microphones are fully charged, the power light will
turn green.
If the microphone is out of range, it will automatically shut off after 30 minutes of trying to reconnect. Once you are back
in the classroom, or in range, simply press and hold the power button on the microphone to power it up.
Tap-to-Talk Student Microphones
STATUS LIGHT
POWER LIGHT
CHARGING
CRADLE
FLEXMIKE
POWER / MODE BUTTON
SHAREMIKE
POWER BUTTON
CHARGING (RED)
CHARGED (GREEN)
TALK (BLUE)
MUTE (WHITE)
STATUS LIGHT
TALK (BLUE)
MUTE (WHITE)
5V/1.0A DC
POWER CORD