Handheld Transmitter - Lightspeed Delta X6 User Manual

3. CHANNEL SELECTION: HANDHELD
TRANSMITTER
Once a channel has been selected on
the receiver, you now need to select
that same channel on the handheld
transmitter. If you have a belt-pack
transmitter, go to page 18 for channel
selection instructions.
1. Turn on the microphone by holding
the power button on the bottom
of the barrel for approximately two
seconds.
2. Use the UP and DN buttons to
select a screen that shows the
current channel.
3. To change the channel, press and
hold the SET button for about 3
seconds until there is a blinking
cursor on the LCD display window.
4. Use the UP and DN buttons to set
the channel to match the receiver.
5. Press and hold the SET button for
about 3 seconds again until the
blinking cursor disappears and the
RED LED flashes.
NOTE: To read the frequency in MHz,
press UP once.
Transmitters and receivers are
available in 3 different frequency
groups. Verify that the letter code
that blinks on the receiver (when
powered ON) matches the letter code
on the silver sticker in the battery
compartment of the transmitter.
7100R
UHF TRUE
DIVERSITY
LightSPEED RECEIVER
A B
CHANNEL
LOW
RF SCAN
BAT
Turn ON
Use UP and
DN to scroll
through screens
until channel is
displayed
Use SET button
to change
and save
new channel
selection
CH: 002
CH: 002
694.500M
NiMH
AKLN
SENS SET
LEVEL [2]
LS
HM-900
Model Number: HM900
Serial Number
HM90014324024
FREQUENCY L-670 MADE IN TAIWAN
SQ
PWR PWR
DN DN UP UP
PWR PWR
DN DN UP UP
PWR PWR
DN DN UP UP
17