Table of Contents
Advertisement
9. CHANNEL SELECTION: BELT-PACK
TRANSMITTER
Channel Selection:
Once a channel has been selected on
the receiver, you now need to select
that same channel on the Belt-pack
transmitter.
1. Turn the transmitter power ON
by pressing the and holding the
PWR button on the side for about
two seconds. The LCD display will
appear.
2. Open the battery compartment
door by depressing the latches on
each side of the transmitter.
3. Use the UP and DN buttons to
select a screen that shows the
current channel.
4. To change the channel, press and
hold the SET button for about 3
seconds until there is a blinking
cursor on the LCD display window.
5. Use the UP and DN buttons to set
the channel to match the receiver.
6. Press and hold the SET button
again for about 3 seconds until the
blinking cursor disappears.
NOTE: To read the frequency in MHz,
press UP once
Transmitters and receivers are
available in 3 different frequency
groups. Verify that the letter code
that blinks on the receiver (when
powered ON) matches the letter code
on the silver sticker in the battery
compartment of the transmitter.
7100R
UHF TRUE
DIVERSITY
LightSPEED
RECEIVER
A
B
CHANNEL
LOW
RF
BAT
CH: 002
CH: 002
694.500M
NiMH
AKLN
Model Number: BP900
Serial Number
SENS SET
LEVEL [2]
BP90014324024
LS
HM-900
FREQUENCY L-670 MADE IN TAIWAN
SCAN
SQ
7
23
Advertisement
Table of Contents
