Qfx-Em-4Q; Figure 20: Qfx-Em-4Q Faceplate And Leds; Table 7: Ex4600-Em-8F Status Led; Table 8: Expansion Module Status Led - Juniper QFX5100 Hardware Manual

QFX5100 Switch Hardware Guide

Table 7: EX4600-EM-8F Status LED

LED State
Unlit
ST
Green

QFX-EM-4Q

Table 8: Expansion Module Status LED

LED State
ST Unlit
Green
36
Table 7 on page 36 describes the Status LED on the EX4600-EM-8F.
Description
The expansion module is offline.
The chassis is powered off.
The expansion module is online and functioning normally.
The QFX-EM-4Q, provides 4 additional 40-Gigabit Ethernet QSFP+ ports to one of the
bays in the QFX5100-24Q or QFX5100-24Q-AA. Port 0 and port 2 can be used for port
channelization by configuring the system mode for 104 port mode.
Figure 20 on page 36 shows the QFX-EM-4Q ports and LEDs.

Figure 20: QFX-EM-4Q Faceplate and LEDs

1— Expansion module status LED
When the expansion module is inserted into the expansion bay, the chassis detects the
additional ports, recognizes them as 40 GbE ports, and lights the Status LED.
NOTE: If a QFX-EM-4Q is installed in PIC1 and EX4600-EM-8F is installed
in PIC2, you must configure the system mode to be Flexi-PIC. Otherwise, only
the EQF-EM-4Q is recognized by the software.
Table 8 on page 36 describes the Status LED on the QFX-EM-4Q expansion module.
Description
The expansion module is offline.
The chassis is powered off.
The expansion module is online and functioning normally.
2— QSFP+ port LEDs
Copyright © 2016, Juniper Networks, Inc.