Table of Contents
Related Manuals for Venmar HDN17 SERIES
Summary of Contents for Venmar HDN17 SERIES
- Page 1 RANGE HOODS INSTALLATION INSTRUCTIONS - USE AND CARE INTENDED FOR DOMESTIC COOKING ONLY READ AND SAVE THESE INSTRUCTIONS INSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER. HOMEOWNER: CLEANING AND OPERATION INFORMATION ON PAGES 8 to 11. 07020 rev. C...
- Page 2 WARNING WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC TO REDUCE THE RISK OF INJURY TO PERSONS SHOCK OR INJURY TO PERSONS, OBSERVE THE IN THE EVENT OF A RANGE TOP GREASE FIRE, FOLLOWING: OBSERVE THE FOLLOWING*: Use this unit only in the manner intended by the SMOTHER FLAMES with a close-fitting lid, cookie manufacturer.
-
Page 3: Table Of Contents
ABOUT THIS MANUAL Because of the large amount of models covered by this publication, the illustrations are typical ones. Some details of your unit may be slightly different of the ones shown. Please take note this manual uses the following symbols to emphasize particular information: WARNING Identifies an instruction which, if not followed, might cause serious personal injuries including possibility of death. -
Page 4: Install Ductwork
1. INSTALL DUCTWORK Plan where and how the ductwork will be installed. Install proper-sized ductwork, elbow(s) and roof or wall cap for the type of blower you are installing. If using 6’’ (150 mm) round ducts, use a transition. Use 2’’ (50 mm) duct tape to seal duct joints. Roof cap Roof cap 6”... -
Page 5: Prepare The Hood
3. PREPARE THE INSTALLATION (CONT’D) NOTE: If the bottom of the cupboard is recessed, attach wood strips (not included), as shown below, in order to properly install the range hood (A) or charcoal filter unit (if need be) to the cabinet (B). The wood strips must be as thick as recess. -
Page 6: Install The Adapter/Damper
4. PREPARE THE HOOD (CONT’D) Using a long nose pliers, remove the knock-outs for the chosen opening (vertical on top or horizontal at the back of the hood). See figures below. ERTICAL DISCHARGE ORIZONTAL DISCHARGE HR0018 5. INSTALL THE ADAPTER/DAMPER NOTE: If this hood replaces another one, please note that the location of the air exhaust can vary from one manufacturer to another. -
Page 7: Install The Hood
6. INSTALL THE HOOD Run power cable to installation location. Place the hood at its location. Using a pen, mark the position of the screws (smaller part of the embossed keyholes). Remove the hood and install (4) 1/2” double thread screws at sides locations (A), leaving a 1/8”... -
Page 8: Halogen Light Bulbs
9. HALOGEN LIGHT BULBS This range hood must use 120 V, 50 W, MR16 with GU10 base or PAR16 with GU10 base, shielded halogen lamps (purchase separately). WARNING In order to prevent the risk of personal injury, do not install a lamp identified for use only in enclosed fixtures. Install the lamps by placing the bulb leads into their grooves in the socket and gently push upward and turn clockwise until secured. -
Page 9: Cleaning
10. CLEANING (CONT’D) ’ TAINLESS STEEL CLEANING CONT Avoid: when choosing a detergent - Any cleaners that contain bleach will attack stainless steel. - Any products containing: chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly. - Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc., are highly explosive and should never be used close to a range. - Page 10 11. OPERATION (CONT’D) ECHANICAL UTTON ONTROL HC0021 A. OFF B LOWER WITCH Press on this switch to stop the blower operation. B. S PEED LOWER WITCHES Press on left switch (1) to turn on the blower on low speed, on middle switch (2) to turn on the blower on medium speed, and on right switch (3) to turn on the blower on high speed.
- Page 11 11. OPERATION (CONT’D) OUND LECTRONIC ONTROL HC0023 A. D ELAY WITCH When a blower speed is selected, press this switch to activate the delay function. The corresponding blower speed switch will flash to indicate this function is activated. The blower will continue to operate for 5 minutes and will stop automatically.
-
Page 12: Service Parts
12. SERVICE PARTS C180, HDN17, V10 V30 S INGLE LOWER ANGE OODS ERIES TY PER ERIE HDN17 ESCRIPTION C180 V10, V30 13296 DAPTER AMPER 16153 MOKED GLASS 16150 LASS HOLDER BLACK THE PAIR 16151 LASS HOLDER WHITE THE PAIR 16152 LASS HOLDER GREY THE PAIR 01988...
Need help?
Do you have a question about the HDN17 SERIES and is the answer not in the manual?
Questions and answers