Takenaka System FS2300DV Instruction Manual page 20

Table 6-5 [OSD menu 4] setting
Communication
command
H'45 Operating cursor
H' Horizontal data Start / Width
✳✳
H'
Vertical data Start / Width
✳✳
H'40 Cursor 1 Set (White)
H'41 Cursor 2 Set (Blue)
H'42 Cursor 3 Set (Green)
H'43 Cursor 4 Set (Red)
● Selection of Operating cursor
It can select the cursor to be changed and to display the settings. It can be changed by entering the argument [H'01 to
H'04] to the communication command "H'45" as follows.
H'01 : to display the data of cursor1 (White)
H'02 : to display the data of cursor2(Blue)
H'03 : to display the data of cursor3 (Green)
H'04 : to display the data of cursor4 (Red)
● Horizontal data Start / Width
It can set the horizontal start position and the horizontal width of each cursor in pixels. It can be changed by entering an
argument to the communication command H'A0 to H'BF. Refer to the command list on chapter 7.
(Note) The sum of the coordinate data of the horizontal start position and the horizontal width should not exceed the
setting range of "H'0018 ~ H'064C".
Dis play area of the monitor
Dis play area of the monitor
Setting of horizontal start position
● Vertical data Start / Width
It can set the vertical start position and the vertical width of each cursor in pixels. It can be changed by entering an
argument to the communication command H'A0 to H'BF. Refer to the command list on chapter 7.
(Note) The sum of the coordinate data of the vertical start position and the vertical width should not exceed the
setting range of "H'0007 ~ H'04C4".
Displ a y area of the monitor
Display area of the monitor
start position
Se tti ng o f V erti ca l
Set contents
(CURSOR)
(X_DATA SX/W)
(Y_DATA SY/W)
(CURSOR 1)
(CURSOR 2)
(CURSOR 3)
(CURSOR 4)
In case of cro ss-s haped c urs or,
the width is not changed even if it were s et.
Setti ng of hori z ontal width
In c a s e of cross-shaped curs or,
the width is not c hanged ev en if it were set.
S etti ng of ve rti ca l w i dt h
- 20 -
Argument data
Default Setting range
H'01 to H'04
H'01
- H'0018 to H'064C
H'0007 to H'04C4
-
H'00 H'01 to H'03
H'01 to H'03
H'00
H'00 H'01 to H'03
H'00 H'01 to H'03
N11A27;20/37