Communication Switches - Ricoh Aficio 220 Service Manual

Printer Switch 0F
No FUNCTION
6 Wait timer for duplex printing
to
0
=No Limit,
7
0
If the duplex unit is already being used for a copy or print job when the fax unit is
going to print a fax message in duplex mode, the fax unit waits until the duplex unit
becomes available. The time that the fax unit will wait can be specified, as shown
above. It the timer expires, the message is printed on single sides.

4.2.4 COMMUNICATION SWITCHES

Communication Switch 00
No FUNCTION
0 Compression modes available
to
in receive mode
1 Bit 1 0 Modes
0 0 MH only
0 1 MH/MR
1 0 MH/MR/MMR
1 1 MH/MR/MMR/
JBIG
2 Compression modes available
to in transmit mode
3 Bit 3 2 Modes
0 0 MH only
0 1 MH/MR
1 0 MH/MR/MMR
1 1 MH/MR/MMR/
JBIG
4 Not used
5 JBIG compression method:
Reception
0: Only basic supported
1: Basic and optional both
supported
6
JBIG compression method:
Transmission
0: Basic mode priority
1: Optional mode priority
7 Closed network (reception)
0: Disabled
1: Enabled
SM
1 0
=1 min., =3 m in.,
0 1
These bits determine the compression capabilities
to be declared in phase B (handshaking) of the
T.30 protocol.
These bits determine the compression capabilities
to be used in the transmission and to be declared
in phase B (handshaking) of the T.30 protocol.
Do not change the settings.
Change the setting when communication
problems occur using JBIG compression.
Change the setting when communication
problems occur using JBIG compression.
1: Reception will not go ahead if the ID code of
the other terminal does not match the ID code of
this terminal. This function is only available in
NSF/NSS mode.
4-41
COMMENTS
1
=10 min.
1
COMMENTS
BIT SWITCHES
A265/A267