Leveling - Maytag MDG18CMNAW Installation Instructions Manual

ELECTRIC DRYER ELECTRICAL CONNECTIONS
Connecting 3-Wire Connection: Optional
Use for direct wire or power supply cord where local codes
do not permit connecting cabinet-ground conductor to neutral
wire.
Connecting Neutral Wire
1. Remove center terminal block screw (A). Also remove neutral
ground wire (B) by removing green external ground conductor
screw (C).
2. Connect neutral ground wire (B) and neutral wire (white or
center wire) (D) of power supply cord/cable under center
terminal block screw (A). Tighten screw.
D

LEVELING

Leveling your dryer properly reduces excess noise and vibration.
1. Remove cardboard from beneath dryer. Place a level on top
edges of dryer, checking each side and front. If not level, tip
dryer and adjust legs up or down as shown in Step 3, repeating
as necessary.
(appearance may vary)
22
3. Connect remaining wires under outer terminal block screws (F).
Tighten screws.
A
B
C
4. Connect a separate copper ground wire (G) under the green
external ground conductor screw (C) to an adequate ground.
Finally, reinstall terminal block to dryer rear panel. Secure cover
with hold-down screw.
A
B
C
G
Not Level
(FOR U.S.A. ONLY)
F
F
LEVEL Not Level