Maytag MDG18CMNAW Installation Instructions Manual page 19

ELECTRIC DRYER ELECTRICAL CONNECTIONS
Connection Options
Power Cord
4-wire receptacle (NEMA Type 14-30R)
3-wire receptacle (NEMA Type 10-30R)
Connecting 4-Wire Connection: Power Supply Cord
IMPORTANT: A 4-wire connection is required for mobile
homes and where local codes do not permit the use of 3-wire
connections.
Standard Power Supply Cord Connectors
Flanged Spade Connector
Connecting Neutral Ground and Neutral Wires
1. Remove center terminal block screw (A) and the neutral
ground wire (B) by removing the green external ground
conductor screw (C).
2. Connect neutral ground wire (B) and neutral wire (white or
center wire) (D) of power supply cord under center terminal
block screw (A). Tighten screw.
D
Direct Wire
4-wire direct
3-wire direct
Connecting Direct Wire Ground
3. Connect ground wire (green or bare) (E) of power supply cord
Ring Connector
A
B
Connecting Remaining Wires
4. Connect remaining wires under outer terminal block screws
C
A
B
under green external ground conductor screw (C). Tighten
screw.
E
(F). Tighten screws. Finally, reinstall terminal block to dryer rear
panel. Secure cover with hold-down screw.
(FOR U.S.A. ONLY)
C
F
F
19