Compressor Clutch - 2.5L Vm Diesel Removal And Installation - Jeep Cherokee 2000 Service Manual

Hide thumbs Also See for Cherokee 2000:

Table of Contents

HEATING AND AIR CONDITIONING

REMOVAL AND INSTALLATION (Continued)

COMPRESSOR CLUTCH - 2.5L VM DIESEL

(1) Disconnect and isolate the battery negative

(2) Remove the compressor from the vehicle. Refer

to the procedure in this group.

(3) Unscrew the compressor drive cup from the

clutch pulley.

(4) Insert the two pins of the spanner wrench

(Special Tool C-4489) into the holes of the clutch

plate. Hold the clutch plate stationary and remove

the hex nut (Fig. 7).

Fig. 7 Clutch Nut Remove

1 – CLUTCH PLATE

(5) Remove the clutch plate with a puller (Special

Tool C-6461) (Fig. 8).

Fig. 8 Clutch Plate Remove

1 – CLUTCH PLATE PULLER

2 – CLUTCH PLATE

(6) Remove the compressor shaft key and the

clutch shims.

(7) Remove the external front housing snap ring

with snap ring pliers (Fig. 9).

Fig. 9 External Snap Ring Remove

2 – SNAP RING PLIERS

(8) Install the lip of the rotor puller (Special Tool

C-6141-1) into the snap ring groove exposed in the

previous step, and install the shaft protector (Special

Tool C-6141-2) (Fig. 10).

Fig. 10 Shaft Protector and Puller

1 – PULLER JAW

2 – SHAFT PROTECTOR

Troubleshooting